Snelle service
Werkt uw apparatuur niet
optimaal? Onze eigen technische
dienst zorgt voor een snelle en
vakkundige reparatie.
Advies op maat
Wat heeft u nodig? Van een
machtigingsvrije portofoon
tot een geavanceerd digitaal
systeem.
Laagste prijsgarantie
Heeft u een offerte? Vraag ons
om een tegenvoorstel en u bent
verzekerd van de laagste prijs.
Daar kunt u op rekenen.

RigExpert AA-230 ZOOM - Antenna and Cable Analyzer 100 kHz to 230 MHz

Lees meer..

Beschikbaarheid: Niet op voorraad. Backorder mogelijk.

€ 469,00 Incl. btw

RigExpert AA-230 ZOOM - Antenna and Cable Analyzer 100 kHz to 230 MHz

The analyzer is designed for measuring SWR (standing wave ratio), return loss, cable loss, as well as other parameters of cable and antenna systems in the range of 100 kHz to 230 MHz.

A built-in ZOOM capability makes graphical measurements especially effective.

An integrated Time Domain Reflectometer mode can be used to locate a fault within the feedline system.

The following tasks are easily accomplished by using this analyzer:

  • Rapid check-out of an antenna
  • Tuning an antenna to resonance
  • Comparing characteristics of an antenna before and after specific event (rain, hurricane, etc.)
  • Making coaxial stubs or measuring their parameters
  • Cable testing and fault location, measuring cable loss and characteristic impedance
  • Measuring capacitance or inductance of reactive loads

Comparison table of RigExpert antenna analyzers

Frequency range: 0.1 to 230 MHz
Frequency entry: 1 kHz resolution
Measurement for 25, 50, 75 and 100-Ohm systems
SWR measurement range: 1 to 100 in numerical modes, 1 to 10 in chart modes
SWR display: numerical or analog indicator
R and X range: 0…10000, -10000…10000 in numerical modes, 0…1000, -1000…1000 in chart modes

Display modes:
- SWR at single or multiple frequencies  
- SWR, return loss, R, X, Z, L, C at single frequency
- SWR chart, 20 to 500 points
- R, X chart, 20 to 500 points
- Smith chart, 20 to 500 points
- Return loss chart, 20 to 500 points
- TDR (Time Domain Reflectometer) chart
- Cable tools (loss and characteristic impedance)

Optional open-short-load calibration.

RF output:
- Connector type: N
- Output signal shape: square
- Output power: -10 dBm (at 50 Ohm load)

Power:
- Four 1.5V alkaline batteries, type AAA  
- Four 1.2V Ni-MH batteries, type AAA *  
- Max. 4 hours of continuous measurement, max. 2 days in stand-by mode when fully charged batteries are used
- When the analyzer is connected to a PC or a DC adapter with USB socket, it takes power from these sources

Interface:
- 290x220 color TFT display
- 6x3 keys on the water-proof keypad
- Multilingual menus and help screens
- USB connection to a personal computer

Dimensions: 82 x 182 x 32 mm (3.2 x 7.2 x 1.3 in)
Operating temperature: 0…40 °C (32…104 °F)
Weight: 236 g (8.32 oz)

* Batteries are not included with the analyzer.

Schrijf uw eigen review